Ignition etc
Entry posted by andydclements
858 views
Last time I was working on the car all seemed sort of OK and it was starting except, one final time and when I pulled the lugs I found the spark was awful, even straight out of the coil.
With some help (remotely) from Matt I've reviewed, cleaned replaced bits and now the spark at the plugs seems better. Today, the car started almost as soon as the starter moved. Hopefully that's the last pulling the dissy etc for a while. I hope this also solves the problem of difficulty getting HC and CO parts of the exhaust emissions both down.
Door lock (glued back together) is back on the car but the little blue piece of plastic fell when it was in the door and I cannot see it, so will have to obtain a new one. So, door trim back on as well.
I also fitted one of the pair of new rear dampers, I am to do the other tomorrow. The old dampers were advised from the MOT test to be watched and with only 40 miles after the test it was obvious the light oil trace the tester had seen was coming fro the damper and wasn't the WD40 we both hoped / thought it was. I had wondered if the shock could be re-sealed but then I noticed why the seals had failed, the plating on the shaft had failed so it would have to be re-chrome shaft and then re-seal or what will actually happen- dump them.
2 Comments
Recommended Comments
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now