Carbon Front access pamel, are there rear supports?

[Matt W]

Sorry this is a request for pics again, at the rear underside of the carbon access panel, are there any supports attached to the front clam? The rear of my panel I just fitted looks too low and it has some lateral movement. Looked on the lotus parts website and there does look to be done sort of support, but the parts diagram not to clear what fits what car. Thanks! 

Edited March 4, 2023 by Matt W

[Paul_D]

Does this help mate?

[R300XXX]

The rear support/fittings should transfer over from your old panel to new one. If it’s sitting low you can buy shims to raise the parts in pic below 

 

These are the shims

 

[Matt W]

Thanks both, as you suggest I need the locating pins, I'll get a couple which will do the trick. Thanks again for your help. 

[R300XXX]

Matt I’ll send you a pm as I have some parts that were sent with my panel, not sure if it’s what you need though

[Matt W]

That would be great, the only bits I need are the locating pins. The upper bit of part 18.on the diagram above. 

[R300XXX]

Frustratingly I’ve only got one side, your welcome to it though, are you sure it isn’t attached to your old panel?