Finally, after 5-6 weeks the new Eltech front acces panel arrived and got installed.
I just want to share some infos with you as it´s not a plug and play install. I like the quality of the carbon and the "V" form of the carbon fibre, just like OEM.
So if anyone considers buying it, here´s the installation manual
Step 1: Remove the original panel and the front grill. The grill is only fixed with 4 screws. I also removed the clips that hold the screws so they won´t fall down somewhere.
Step 2: Remove the front wheels and the whell arch liners. Look for the plastic screws so you don´t destroy them. Remove the one metal screw and take the upper part of the wheel arch liner out. Then remove the 4 screws that hold the remaining plastic cover on each side. Install the wheel arch liners and wheels again.
Step 3: Now that the original panel is completely removed. Try to fit the new panel. In my case, it didn´t fit, so we had to use a dremel to remove some milimeters of the left and right notch where the original three pins of the grill would fit in.
Step 4: Remove the upper left and right pins and the rod for the lock from the original panel. You´ll have to use new screws for the small 2 pins as the original ones don´t fit. Think it were four M5 screws needed. Widen the wholes in the brackets to make the new screws fit. Haven´t taken pictures of this step unfortunately.
Step 5: Fit some Screws with washers to the two holes in front of the new panel. In my case, we had to replace the rubber things too as I lost two of three of the original parts. They are really loose..
Step 6: Don´t forget to place a rubber cushion/bumper or so on the panel where the switch for the alarm is placed. If you don´t there is a good chance that the alarm is triggered even when the panel is in place.
Step 7: Fit the new panel and take a picture