2011 Chrome Orange
Basic Account
-
Joined
-
Last visited
Solutions
-
2011 Chrome Orange's post in Service Access Panel Hinge was marked as the answerThe manual states..
Panel Hinge
"The hinge stator is secured by two M5 nyloc nuts to a bonded studplate on the clamshell, with sufficient hole tolerance to allow some adjustment of panel height.
Similarly, the hinge rotor is secured by 2 M5 nyloc nuts to a studplate in the cover, with allowance made for adjustment of shutlines."
-
2011 Chrome Orange's post in Cannot get boot open, mechanism working but not freeing latch. was marked as the answerSince you got it open, set up the preventative measure for the future.
-
2011 Chrome Orange's post in Red NA Engine Cover was marked as the answerThey are chrome.
-
2011 Chrome Orange's post in Exhaust manifold removal - tips? was marked as the answerThere's a how to with photos posted here..
https://www.lotustalk.com/threads/complete-larini-header-and-exhaust-diy.322593/
-
2011 Chrome Orange's post in Jacking points was marked as the answerYou can jack the rear lift point and place a stand under the front lift point. Then, if you have a second floor jack, you can place it under the rear tire (which would already be up in the air) with a small board and jack the rear tire to remove the first jack and replace with a jack stand.
Just make sure you are doing it on level ground with the other side chocked. And, obviously do not go under the vehicle until it is fully supported on the stands.
Before I bought my 4 post lift, that is how I would get my Evora on 4 jack stands using the appropriate lift points.
-
2011 Chrome Orange's post in Guide how/where to fit the rear clam badges (text)? was marked as the answerNot my picture but should help....
