Wysia

The cause of the failure was poor soldering of the PLCC sockets to the motherboard (ECU).

Hello! I have problem with starting the 918 engine 😐 I bought an O2 sensor (BOSCH 0258005133) and replaced the RH Pre-cat sensor. I did everything with the battery disconnected. When I restarted the ignition, I heard a bad sound from "Oxygen sensor heater control relay" (several ticks per second). I disconnected the new sensor and installed the old one (on which everything was OK before). The relay ticks several times a second and the car does not start. Please watch this video. I checked all the fuses in Fusebox "B". All are OK. I also replaced the gray relay. I also checked the harness in the engine section. No damage visible. The vehicle does not start at all (the starter turns). It appears that the ECU is unable to complete the self-diagnosis process immediately after the ignition is turned on. The fuel pump does not start and the IAC valve does not make any noise. I had the ECU checked under a microscope. Everything is OK. There is no visible damage or cold solder joints. I cannot connect TECH-1 (it reports a failure and asks to check the connection). Have you had this same problem before when replacing the o2 sensor?

I am looking for different interior leather trim parts for Esprit S4/V8. If you have anything, please message.

I'm looking for COBO side/indicator lamps for Turbo SE (EU, not USA). I care more about housings, but I can buy with lens.

I need all elastic carpet protectors next to the footwell of the passenger and the driver. Can you tell me where to buy it? Or would you like to sell your used interior carpet set with these protectors? I will buy.

Hello friends, I'm finishing assembling my 93.5 (LHD) after several years of work. I don't know what connect to the few connectors inside the vehicle. Please help and tips. I have a wiring diagram but couldn't find anything. Above the tunnel, near the headunit and air knobs. 1 pin connector (double purple) 1 pin connector (one yellow) 4-Pin connector Outboard end of the glovebox (electric harness from the alarm controller harness) 1-pin connector (orange + white) 6-pin connector Please see attached pictures.

@cweeden Do you want to sell these tools? I need a few for reconditioning my engine: T000T1248F, T000T1249F, T000T1272F, T000T1338F, T000T1336F, T000T1391/1.

Hi Guys, i'm looking for a few engine reconditioning tools. I will buy. Maybe someone has these parts and they don't need them. Timing Disc - T000T1391/1 Timing pointer for V8 Engine (Mounted in the sump fixing bolt) Locking Cap, camshaft - T000T1336F Alignment Tool, camshaft timing disc - T000T1338F Injector Housing alignment plate - T000T1272F Flywheel Locking Tool (transmission removed) - T000T1249F Locating Plate, intermediate shaft - T000T1248F

MrDangerUS, do you have any contact to the current owner in Poland? I also live in Poland and I am currently work two Esprit restoration projects: 93.5 oraz V8 '99. We even made the tanks in the same company

Hello all! Do any of you know what this bracket is do? Maybe someone has a photo of this part in the vehicle? Can't see it on the parts diagrams. I just assemble the door after a long break and I do not know what this part is do.

Hello, I have to do setting the Wheel Alignment in my Turbo SE'91. I would use the standard SE settings. Can I get also an instruction in pdf? I do not have specific specs Paul '91 SE