geoft
-
Posts
32 -
Joined
-
Last visited
About geoft
- Birthday September 12
Recent Profile Visitors
1,561 profile views
.thumb.JPG.e0c3c0a8fac58165e8833b957e1438bf.JPG)
geoft's Achievements
-
Thank you everyone for replying. I got to the bottom of it. They are 5/16" UNF.
-
Hi.. The parts listing says the cover bolts are M8 x 30 Long. These don't fit the threaded holes. Does anyone know the correct size please? I am thinking maybe M8x1.0 pitch or 5/16" BSF?
-
Thank you, what I did not mention is that the engine is out now before body lift and when putting the body back the engine will be in place. I am making trestles and want to get the correct height without hitting my garage ceiling with the roof. -
Hi. Does anyone know how high I would have to lift the bodyshell up to roll out the chassis on my Esprit please? The reason is I have limited headroom in my garage. Thank you in advance.
-
Thank you CarBuf for your offer of a picture. I have now found a picture in the parts manual. Thanks again.
-
Hello. Can anyone help with the rear brake pipe and flexible layout please? I got the car stripped down. Thank you in advance.
-
ESPRIT CARPETS (50 sets and rising)
geoft replied to Steve V8's topic in Esprit 'Project & Restoration' Room
Hi, Who do I contact for a set please? -
Large titanium washers – All Esprits ’88 onwards
geoft replied to lotusforsale.com's topic in For Sale
Hi Do you have any of these left please? Regards -
Hi Does anyone know if there is an equivalent driveshaft for this car. I assume they maybe Toyota. Thanks in advance.
-
Hi Pete. Thank you for info. I have the column stripped and carefully labelled the shims etc. there is a spring on the lower bearing but not the top. I have also made a new top aluminum housing to hold bicycle crank bearings. I guess that I could make a bronze lower bearing as the car won't go that far if I ever finish it!! Regards
-
Hi, does anyone know what I can use for a replacement bearing please?
-
Hi John, thank you and I have now sorted it out. Regards.
-
Hi, can anyone help please? Do you have a photograph of the Steering Rack Hydraulic Pump in situ on the engine please? I cannot get where it should bolt on to, as I have put in engine back without doing it. Thank you in advance if you can help.
-
Can anyone tell me what part (plate, bracket, etc.) that secures the bottom of the radiator to the body please? The bottom holes are at an angle and do not match the body profile. Also the top twisted straps where do they attach to the body please? Cannot find a hole anywhere. Any pictures most welcomed?
-
Air Con Belt Tensioner Bearing Elite S1
geoft replied to geoft's topic in Engine & Ancilliaries/Gearbox
Oh yes. Thank you. Was on the site this afternoon looking as well. Thanks again.
